Thanks! I use a hot air solder station. You definitely need flux as well! Apply flux, tin pads, place chip, heat from above. The big flash chip was to play with USB mass storage. Hope this helps!
@blakesmith As someone that dabbles in PCB design and embedded Rust I enjoyed your Rust on a ATSAMD51 post. I had a couple of questions. How did you solder the MCU to the board? What's the purpose of the big flash chip?
-
-
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.