Conversation

I spent quite a lot of time on what is ultimately just a mock-up geometry for a 3d printed heat exchanger component, & it's not capped, or manifolded yet but damn if it isn't exciting to see this 3d rendered this is a gyroid (from grabcad) stretched, distorted, and wrapped
Embedded video
0:06
2.5K views
16
118
Replying to and
I used blender / lattice distort to compactify the double gyroid from grabcad, and then replicated a rotate and move, with a ton of manual adjustments so the mating would be close to seamless. when i comes time to actually print i will probably have to gen geometry from scratch
1
2
Show replies