Conversation

iphone proved impossible. Will have to improvise some sort of fixture for it. Webcam on desk monitor seems more promising. Not sure why I'm getting reflection artifacts. I think interior of the thing isn't nonreflective enough perhaps.
Image
1
3
Getting some diffraction gratings soon. Might try to make my own. Interesting question… those numbers *say* 4, 5, 6, 7… supposedly 100s of nanometers, but how do I know? What if the experts have been lying to me all along? What if there’s a conspiracy to rig the scale?
1
6
I could calibrate the yellow sodium line with a candle and some salt on a needle, but again I have to take their 3rd for it. Only way is to check the derivation from the grating geometry and measure the grating line spacing myself… supposedly 13.5k lines per inch.
1
5
I vaguely recall learning the operating principles of diffraction in high school. Some shit about waves and angles. But tbh I’ve completely forgotten it. Need to brush up.
1
7
Really weird that I can’t find a good broad spectrum light source at home. All my lamps are CFLs or LEDs, and my workshop also has only LEDs. Gonna have to actually find a small incandescent lightbulb somewhere. These things might soon be hard to find.
4
6
Replying to
Made a lens holder. Idea is to run it on an aluminum square tube to make an optical bench but I got the tolerance of square hole wrong so it doesn’t fit. Lens sits nicely though
Image
Image
2
5
Success! Modified design to be to have a clampable top. Now to make similar fixtures for other lenses, mirrors, light source, screen… I have a cunning plan to bend the light path with right prisms.
2
8
Bought a pair of right prisms and verified the principle of total internal reflection for myself. Now I can use binoculars and trust they’re not a conspiracy. Do your own research.
2
18
Made a dovetail joint lamp fixture. Will need a box and collimating lens around it, but trying to get basics right. Bulb sits a bit loose 😕
Image
Image
1
1
Used this 5mm copper tape for the connection. This sucks. Connection doesn’t work well. Contact is too light.
Image
Image
Image
1
2
Discovered not 1 but 2 embarrassing mistakes. The first fixture was effectively a short since I didn’t notice that the cylinder terminal of the bulb had a ring at the bottom contacting the copper for the bottom nub terminal. Fixed with a bit of insulated tape, and now works fine.
Image
1
1
Second mistake: assumed the bulb has a nearly spherical beam. It doesn’t. It’s like a 30 degree cone, and pointed the wrong way by 90 degrees relative to the light path,
Image
Image
1
1
This has turned into a yakshave where I’ve completely forgotten the original point of whatever the hell I’m up to here
1
4