Uh oh a bit of stringing has appeared. But much less than before, and likely due to the overhang geometry I’m trying… there’s a V-groove on the inner rim at 45 degrees
Conversation
Done. Some stringing and a bit of one skirt lifted off but overall looks good.
1
1
This is vastly superior. It looks better without cleanup than the first one with cleanup. This is the “tire”
1
1
Age-restricted adult content. This content might not be appropriate for people under 18 years old. To view this media, you’ll need to log in to Twitter. Learn more
In the second “tire” print, you can kinda see the groove there though black is a hard color to see shadows in. In previous print, it was jammed up in stringy goop.
1
Time to get serious. Let’s try something that looks like a tire. 20% infill. Basically a spur gear with a shallow chamfer and large bore. If this works well I’ll design some treads.
1
Lookin’ good so far.
1
3
I think the inner v-groove in first tire was too aggressive. This one has a flat inside profile, but I suspect if I want a gentle concavity to fit a barrel-shaped hub, it'll work fine. The stringing was caused by the v notch. And I don't think supports are a good idea with TPU
1
This turned out so beautifully I have a tear in my eye 🥲
1
10
Replying to
I honestly didn't think I'd be able to get this right... I ordered several sets of toy wheels, expecting I'd have to buy rather than build, but my rover is going to have made-from-scratch wheels
GIF
read image description
ALT
1
7
Btw turned out I didn’t need the mod part. That was for older model I guess. My printer does TPU without mods.
1
Yesterday’s success with TPU inspired me to try PETG again. Tried TPU settings (slower movement, overextension) but that didn’t extrude stop all! Realized overextrusion is for soft filaments and PETG is stiffer than PLA. So dialed that back and just used lower speed. Worked ok.
2
1
Some stringing but PETG wasn’t as bad as TPU last time do improvements with slower speed are less marked.
1
1
3d printed art subthread
Quote Tweet
Haven't been in the mood to work on my more complex designs/builds in a few weeks, so just to keep warmed up, decided to make a random art piece to test out freeform smooth curves. This inaugurates my 3d printed art thread.
Show this thread
1
1
