Conversation

Fingers crossed. Seems to be printing fine. Shiny with some stringing. Used Cura generic presets for TPU-95, whatever that is. Higher nozzle temperature (228F) but lower bed temperature (45) than PLA (205/65)
Image
2
Decent compliance, rather stiff at normal resolution printing with 60% infill. I bet I could get much wider range by messing with infill density. But clearly settings need work. But unlike PETG this feels different enough as a material, it’s worth mastering.
Embedded video
0:12
1.1K views
1
4
Well finished printing a set of sample things. This comes out looking like the work of a deranged spider like in LOTR. Doesn’t have to. I’ve seen videos of clean TPU prints. Just have to figure out settings.
Image
1
6
Ok trying this dude’s settings now. His main thing is increasing the flow rate by 30% and lowering the speed to like a third, from 50mm/s to 18. Can already tell it’s working way better. Impressed. I gotta try this stunt with PETG too.
Embedded video
0:03
415 views
2
2
Show replies