Also reprinting the horns from yesterday. Scaled down 50% with raft. Dunno what all that wispy stray fiber is. Too dry? From supports being printed coarse? PLA spool being not as good? Drip during travel?
Conversation
Done. Messed up a bit tried to make the triangle equilateral and the rectangle a square at the same time. Doh. No way to satisfy this template. If you have a square, triangle will be isosceles.
1
1
3
The horns printed fine but that fuzz is a mess. Not sure it will clean up easy.
1
After some cleanup. Not much better.
1
1
Called on the brain trust for help.
Quote Tweet
3d printing mavens… any tips for sanding PLA prints down to a smooth finish? @divalbanerjee @h_thoreson @chenoehart
1
Much excite. Printing TPU for the first time. If it works I’ll be able to design my own tires 🥳😱
en.m.wikipedia.org/wiki/Thermopla
Just a simple rubbery washer to start with.
2
5
Fingers crossed. Seems to be printing fine. Shiny with some stringing. Used Cura generic presets for TPU-95, whatever that is. Higher nozzle temperature (228F) but lower bed temperature (45) than PLA (205/65)
2
Decent compliance, rather stiff at normal resolution printing with 60% infill. I bet I could get much wider range by messing with infill density. But clearly settings need work. But unlike PETG this feels different enough as a material, it’s worth mastering.
1
1
4
This Tweet was deleted by the Tweet author. Learn more
