Conversation

Replying to
Brainwave! Since wick was sticking to the tab last time, maybe that can be a feature here! Idea is maybe solder-soaked wick will bind to both lead wire and plastic housing AND maybe deep under plastic tab and make contact. Put some wick under wire and try to glob up both!
1
1
Okay, last solder experiment of the day. Let’s try leaded on a pcb. With some of the new 24 awg solid core I bought. Result: beautiful. Far better than the older lead-free soldering I did on same board.
Image
Image
1
2
Let’s wrap for today with a clean-up note. I’ve really learned to appreciate the value of leaving a workshop as clean as you can for next time. Silicone mat is a mess after all that genius work. But I have discovered an easy genius clean-up hack: a bit of tape!
Image
1
6
Replying to
On the menu for next time: trying to solder leads onto male JST connectors. These are designed for board-to-wire boardside, not wire-to-wire, so you have to solder on rather than crimp on. Also: try these solder-seal connectors that can be done with a heat gun.
Image
Image
1
1
Fixed a charger for the halo strap that got chewed up by cat. Had to cut away chewed up part, strip the two coax conductors and solder them. Worst job ever but it does work again. I ended up twisting ends together pointed the same direction. It was too hard to do a butt join.
Image
Image
Image
Image
1
2
For extra credit fixed chewed up MacBook charger too. Cats are a menace. They almost cost more in chewed up cords and cables than food.
Image
4
6