Ok spoke too soon. Haven’t cleared jam. It pulls filament through up to a point, but then starts slipping. Nozzles at 190. What do now?
I think the jam is near the nozzle
Conversation
Replying to
Can you see the part of the filament in the extruder? There might already be a hole carved in it so when the extruder gear gets to that spot there's nothing to push on. Might be able to push the filament past with your fingers.
1
Replying to
I think the blockage is near the hot end. It gets pulled in quite a ways before the clicking noise starts as the extruder motor slips.
1
1
Replying to
Yes, it goes in/out like 6” from the insertion point so I think blockage is at the nozzle or just upstream from it
1
Replying to
I’m holding off doing that till I get my cleaner filament and some micro drill bits. There seem to be a few different paths on the troubleshooting tree.

