Sticky print folklorehttps://twitter.com/vgr/status/1297305161862242305 …
-
-
-
-
Round 2: doorstop and whiteboard clamphttps://twitter.com/vgr/status/1300614399640522752 …
Show this thread -
First experiment with overhangs and supports. Took 3 tries to get it right.https://twitter.com/vgr/status/1325934791414345729 …
Show this thread -
-
Printing a roller for wife’s pottery experiments. Also just designed a stamp based on a photo she found, queued up to print next. Learned a few new OnShape tricks doing that. This is the most CAD I’ve done in 25 years.pic.twitter.com/eUarNoO4gt
Show this thread -
Next personally challenge: figure out how to use the damn onshape spur gear generator featurescript.
Show this thread
End of conversation
New conversation -
-
-
What printer are you using? I think I am close to pulling the trigger on an Ender 3 pro, "for homeschool purposes"
-
Monoprice
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
Did it with OnShspe+Cura... haven’t used CAD software since 1996, which was ancient version of ProEngineer. Things have really advanced a lot. Browser+cloud-basedwith version control and all sorts of other crap.
The tolerance is a little off, so it’s not quite a snug interference fit. Wondering whether to reprint or use this with a bit of tape or something to line it for a snug fit.