Fun part was making a pattern of holes, so got to learn that trick in OnShape. No reason other than to save material.
-
-
Show this thread
-
Part 2. Needed an extra bracket/brace thingie to clamp the top of my whiteboard which was wobbly (came with 2 both of which I used for the bottom edge). So took off and measured one of the existing ones with callipers.pic.twitter.com/5aBShHtc4T
Show this thread -
You’ll notice it’s a z-shape with 2 triangular braces which won’t print without supports. So designed and printed one with just 1 brace, but a thin triangular support ridge at corner. Since this is going on top edge figured it’s good enough.pic.twitter.com/ffHKNj2qVy
Show this thread -
Drilled a hole. Managed to get it off center. This extended 3d printed ribbonfarm universe is not very symmetric is it?pic.twitter.com/sthukbwL37
Show this thread -
Installed... but le sigh... guess I measured badly. Off by like 2mm and didn’t clamp. BUT had this random bit of scrap plastic lying around because I’ve been lazy about tossing stuff. This was tie down strap for a set of socket wrenches I bought recently and only just opened.pic.twitter.com/PteeT3qe3o
Show this thread -
So cut off one of those stemmy bits and jammed it into clearance space. Perfect. The whiteboard even happens to have grooves there that make it fit neatly.pic.twitter.com/2WIvMBJse5
Show this thread -
-
The doorstop works out to $1 marginal costhttps://twitter.com/vgr/status/1300654066612068353 …
Show this thread -
Cheapest I found on amazon is $14.95 for a 10-pack, so $1.49... so this is about 33% cheaper. Plus I only need to print 1 and don’t have to buy 10. The singles are really expensive and most are 4 packs at least.https://www.amazon.com/Stoppers-Minimalist-Neoprene-Resistant-gripping/dp/B07YD58YLQ/ref=sr_1_24?_encoding=UTF8&c=ts&dchild=1&keywords=Door+Stops&qid=1598935129&sr=8-24&ts_id=1069196 …
Show this thread -
Even with a reasonable printer amortization schedule over 10 kg, still works out pretty cheap. $1.82https://twitter.com/vgr/status/1300659116935753730 …
Show this thread
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.