Success! 3d printed the lost telescope cap cover! With vanity logo too 😎
The tolerance is a little off, so it’s not quite a snug interference fit. Wondering whether to reprint or use this with a bit of tape or something to line it for a snug fit.
Conversation
Okay with cooling it's loose enough it falls out. Anyone know how to measure a tiny gap so I can adjust the dimensions for a better fit? Also how much of an interference is good for PLA?
7
1
Replying to
I have those too, but subtracting 1 large number from another in a coarse print job is not exactly very precise...I think I'm down to trial and error. Cant measure my way out of this.

