Okay with cooling it's loose enough it falls out. Anyone know how to measure a tiny gap so I can adjust the dimensions for a better fit? Also how much of an interference is good for PLA?
-
-
Show this thread
-
I do have feeler gauges, but it only goes as low as 0.25mm and that gauge is just a bit too thick. So I'm guessing the gap is ~0.2mm and I need to maybe add 0.3-0.5mm to the diameter to get the fithttps://twitter.com/neilggrupert/status/1299839515331162112 …
Show this thread -
Printed version 2 which fits snugly (had to sand a bit... but I’m not printing V3... I know when to quit). Just need to print and glue on a handle. Needed 2 parts due to overhang
Show this thread -
New conversation -
-
-
looks like a pretty good fit. maybe a dab of silicone caulk on the edge (it's grippy and will widen it a bit)
-
You might also be able to get hold of a rubber gasket that will match the ID of the cover, more or less.
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
The tolerance is a little off, so it’s not quite a snug interference fit. Wondering whether to reprint or use this with a bit of tape or something to line it for a snug fit.