Even this extremely simple part (2 circles, 2 extrusions) was a nightmare to figure out. Felt like a caveman.
-
-
The way to test this would be to run an experiment at different bed levels with the same print, and measure the force needed to get it off, but I don't want to... direct on plate is too temperamental for my tastes. Gonna try taped up approach next.
Show this threadThanks. Twitter will use this to make your timeline better. UndoUndo
-
-
-
Also try adding a “raft” in your slicer. This is a small base layer of plastic before your actual thing prints. Makes it much easier to peel off. You can see the raft in this picpic.twitter.com/6a8BEGZKox
-
Yeah I turned it off as a test... mistake
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
