Terry Burns-Dyson

@terryburnsdyson

Software developer

New Jersey
hypersonicscream.com
Joined April 2009
68 Photos and videos Photos and videos

Tweets

You blocked @terryburnsdyson

Are you sure you want to view these Tweets? Viewing Tweets won't unblock @terryburnsdyson

  1. Jun 4

    I was following the instructions for the tarantula alone so I could give an honest opinion.its if you buy it, it!

  2. Jun 4

    Put quite simply,one of the worst set of instructions I have ever had the misfortune to try and follow

  3. Jun 4

    I am thankful for because if I had to use tarantula build instructions alone I would have tossed the lot in the bin!

  4. Jun 1

    Fugatech 3D Printing 2000 Subscriber Giveaway

  5. Jun 1

    Getting organized,this is my 3d printing kit

    2 retweets 2 likes
  6. Retweeted
    Jun 1

    at w/ and their M3

    4 retweets 10 likes
  7. May 30

    Low poly yoshi printed in orange pla on cr-10.bit too hot methinks but print came out awesome!

    2 retweets 2 likes
  8. May 29
    Replying to

    Autocomplete made that front,pretty obvious Groot. :)

  9. May 29

    Baby front, found on thingiverse. Printed using wood PLA

    1 reply 1 retweet
  10. May 29

    Inspired by ,remember seeing the paper rescue trick a while back.was not surrendering the print.

    1 reply 1 retweet
  11. May 23

    More in the series of thread organizers for my wife. The rebel logo would only fit on my nice…

  12. May 19

    Got a Creality cr-10,what an incredible printer.20 minutes from unboxinf to printing.4 hours later...

  13. Retweeted
    May 13

    This father just destroyed his representative over Trumpcare

    This Dad Went Off On His Rep Over Trumpcare
    You have to watch this speech
    1,772 replies 63,986 retweets 103,963 likes
  14. May 13

    Do I have a too few 3d printers problem or a hoarding issue?

    1 reply
  15. Retweeted
    May 1

    BASIC computer language is 53 years old today. Retweet if BASIC was your first computer language?

    796 replies 21,418 retweets 8,635 likes
  16. Apr 23

    Could do with some washers, locking nuts and needs a few mods but otherwise good start

  17. Apr 23

    Got a Tronxy X3,took a long time to build but first print coming off marvelous.

  18. Apr 20

    When buying a $150 3d printer,you get what you pay for.The parts.

  19. Apr 16

    If you consider yourself a touch typist,get hold of a typewriter and try typing without backspace.

  20. Apr 13

    Cincinatti, OH->Kearny,NJ->Bayville(passing Brick)->Trenton->Brick->Kearny->California Efficiency.Taxpayer money at work!

@terryburnsdyson hasn't Tweeted yet.

Loading seems to be taking a while.

Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.

    You may also like

    ·