@starsandrobots I do not get why so many people use Eagle (there are other CAD programs not called Altium that are free) T_T
-
-
Replying to @starsandrobots
@cr1901 any specific recommendations well-suited to this purpose?1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots I use DipTrace personally; (very) easy to make parts, far less aggravating UI, and fair free version limitations.2 replies 0 retweets 1 like -
Replying to @starsandrobots
@cr1901 it's also no more free than EAGLE is.2 replies 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots I run into the board space limitation much more frequently than I do the pin limitation, but I also forgot something >>1 reply 0 retweets 0 likes -
Replying to @cr1901
@starsandrobots important; I'm not making the same type of PCBs that most hobbyists do (vintage w/ DIPs).4 replies 0 retweets 0 likes -
Replying to @cr1901
@cr1901 have you read http://www.boldport.com/blog/2015/2/5/a-farewell-to-eda …?1 reply 1 retweet 0 likes -
Replying to @starsandrobots
@starsandrobots I have not! I am not too choked up if that's true however :D.1 reply 0 retweets 0 likes
@cr1901 you might like taking a look at @pcbmode and http://boldport.com sometime!
-
-
Replying to @starsandrobots
@starsandrobots@pcbmode Well, for better or worse, I *have* to make the leap to SMT for my next project. Might be a good time to "reboot".0 replies 0 retweets 1 likeThanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.