@starsandrobots @othermachine using an engraving end mill? What tool? Recently I tested aluminum engraving at 1500 mm/min and it did fine
-
-
Replying to @dapplestone
@dapplestone@othermachine yep engraving endmill! Can't figure out how/where I set feed+speed though.. ?1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots@dapplestone are you using Otherplan or different CAM software?1 reply 0 retweets 0 likes -
-
Replying to @starsandrobots
@starsandrobots@dapplestone you can’t manually set speeds/feeds in Otherplan yet, but we are adding this in the next release!2 replies 0 retweets 0 likes -
Replying to @ahhrrr
@ahhrrr@dapplestone (thanks for helping me with this on your Saturday!)1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots@ahhrrr honestly, if you just engrave at the standard speeds and feeds for pcb milling, (the default) you'll be just fine.2 replies 0 retweets 0 likes -
Replying to @dapplestone
@dapplestone@ahhrrr ahh but I can't select to cut w engraving bit & 1/64th tool is much longer, so not scratching surface. So, will wait!1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@dapplestone@ahhrrr jk! Faked material thickness. It's back on.1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots@ahhrrr I cannot wait for the next release! All these issues will be moot. Send pics!1 reply 0 retweets 1 like
@dapplestone @ahhrrr I have pics a cut from last weekend at least!
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.