@othermachine hi hi! I am currently following the ano aluminum 'ible, looking for feed/speed setup info for aluminum.. pointers?
-
-
Replying to @starsandrobots
@starsandrobots@othermachine using an engraving end mill? What tool? Recently I tested aluminum engraving at 1500 mm/min and it did fine1 reply 0 retweets 0 likes -
Replying to @dapplestone
@dapplestone@othermachine yep engraving endmill! Can't figure out how/where I set feed+speed though.. ?1 reply 0 retweets 0 likes -
Replying to @starsandrobots
@starsandrobots@dapplestone are you using Otherplan or different CAM software?1 reply 0 retweets 0 likes -
-
Replying to @starsandrobots
@starsandrobots@dapplestone you can’t manually set speeds/feeds in Otherplan yet, but we are adding this in the next release!2 replies 0 retweets 0 likes
Replying to @ahhrrr
@ahhrrr @dapplestone yay! hm, is there any way to do this e.g. with the gcode I'm loading that I could look up to use for just this weekend?
11:07 AM - 12 Jul 2014
0 replies
0 retweets
0 likes
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.