@starsandrobots @othermachine using an engraving end mill? What tool? Recently I tested aluminum engraving at 1500 mm/min and it did fine
@othermachine hi hi! I am currently following the ano aluminum 'ible, looking for feed/speed setup info for aluminum.. pointers?
-
-
-
@dapplestone@othermachine yep engraving endmill! Can't figure out how/where I set feed+speed though.. ? -
@starsandrobots@dapplestone are you using Otherplan or different CAM software? -
@ahhrrr@dapplestone Otherplan! -
@starsandrobots@dapplestone you can’t manually set speeds/feeds in Otherplan yet, but we are adding this in the next release! -
@ahhrrr@dapplestone yay! hm, is there any way to do this e.g. with the gcode I'm loading that I could look up to use for just this weekend?
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.