@oe1cxw Is the labeling of the P1 and P2 connectors in this diagram correct? http://icoboard.org/uploads/images/Layout.4_17.png … Shouldn't they be swapped?
No, this is correct. Consider that pairs of PMODs can be used together. Lower index should always be on same side of module..
-
-
I enabled gpio on pmod1 only (icosoc.cfg); got led blinking on the connector near the side with the "icoboard gamma" label, confused
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
-
-
-
I can look at it when I am back in Vienna, but this pic is wrong by definition for the reason I mentioned before. If
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.