Hey people who know things about hardware glitching: if I want to fiddle with reset pc control would I want to mess with Vcc in addition to RESET or might RESET alone be sufficient? I have a setup that I could easily throw analog voltage at RESET with, but not Vcc.
-
-
Replying to @endrift
Depends entirely on the target. Reset glitching and Vcc glitching are different things. One might work where the other one doesn't. With glitching you usually want to have very good timing control, though sometimes all it takes is tapping wires together.
1 reply 0 retweets 4 likes -
Replying to @marcan42
This would be an AGB-CPU in 5V mode, though I discovered my ADC is 3.3V so it probably won't work too well :/
1 reply 0 retweets 0 likes -
The goal here is to dump the AGB variant of the CGB boot ROM.
2 replies 0 retweets 0 likes -
Replying to @endrift
Usually for reset/clock glitching we're talking about sub-clock-period glitches, digital rather than analog. Analog isn't likely to make it very far into a chip, other than it potentially being converted to a less than clean digital signal.
1 reply 0 retweets 0 likes -
Replying to @marcan42
Oh I see. Yeah I don't think I have anything that can do that then. Dang :/
2 replies 0 retweets 0 likes
We know that at least the CGB CPUs in pre-AGB models used dynamic logic and got really confused by clock screwery though, so maybe just try some good old shorting things out by hand first? Sometimes simple approaches work.
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.