I just spent 6 hours figuring out how to update buggy, data-eating SAS disk firmware on an HP ProLiant server. This is ridiculous. Get your shit together, @HPE.
-
I figured their general firwmare update DVD would do the right thing, but it didn*t even work at all (unspecified error). I tried init=/bin/sh to get a shell, but nope, I could update all firmware *except* the HDDs. Still not in "offline" mode.
Turns out if you boot the HP Offline Array Configuration Utility, then switch to a terminal and ^C, you can get a shell. Then you can configure the network, wget the firmware update, run it, and **THAT** works. Somehow puts the controller into the magic offline mode.
-
-
Did you try pouring water on the NICs to be sure?
-
No, but I did try updating the NIC firmware while I was in the updater DVD. *That* failed too, halfway through. Turns out you have to rmmod and re-modprobe and re-up the interfaces between boot code and PXE/iSCSI firmware updates, since it jams after the former. I don't even.
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.