3D print hell, part 17, support Z distance: 0.3mm: part tips off support during printing 0.1mm: zeus himself could not pull off the support
-
As far as I know, without the optical feedback from the pickup itself onto the pre-groove, focus are tracking effectively become open-loop.
Angular tracking is a problem too (normal burners just don't care except roughly on average). Friend built some FPGA-based PLL thing.
-
-
... which worked fine for visual purposes but for nm-scale tracking you really need some accurate angular feedback too.
-
Fun fact: some copy protection schemes, like GC/Wii's, rely on lack of angular repeatability. You can get good enough to fool them though.
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.