3D print hell, part 17, support Z distance: 0.3mm: part tips off support during printing 0.1mm: zeus himself could not pull off the support
-
I've thought about whether you could do it radially with a modified bluray drive...
A friend did something similar, but not nm-scale (just for decorative purposes). You kind of need a patterned surface for tracking though.
-
-
I'm not sure you could sensibly modify a typical pickup to track without a pre-groove to lock on to (i.e. blank disc).
-
There might be some other side channel you could track by...?
- Show replies
New conversation -
-
-
Yeah. I was thinking you'd start with wafers marked for tracking, lay out design radially.
-
Yeah, if you had a spiral groove marked on them like a blank disc, I could see that working (if the optics part works out).
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.