My right Joy-Con went crazy and its P1 LED went red. It's a *green* LED. Fault caused overdrive. Now it's dimmer/damaged. (video=simulation)pic.twitter.com/b2fDJNYN7w
-
I suspect some metallic/solder residue bridged the current limiting resistor. There is some questionable looking dust inside.
Holy shit, I just figured out the problem. Nintendo used the wrong screws inside my Joy-Con. They didn't reach through the PCB and fell out.
-
-
I found two screws rattling inside and the PCB wasn't independently screwed in, only via the plastic piece on top. iFixit photos confirm.
-
I think they swapped the pair meant for the rail buttons PCB (short) with the pair for the main PCB (long).
- Show replies
New conversation -
-
-
Wow. You used to rely on Nintendo to make perfect hardware.
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.