@printrbot any way to clean out with a pipecleaner or somethin like that. Shouldn't need to take all apart to clean out little bits.
Extruder got jammed with PLA inside somewhere. Couldn't clean out. Have to remove whole head assembly arg. @printrbot
-
-
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
-
-
@inthecloud247 I’ve had PLA form a wad at the top … It might be easy. Heat it up and you might get lucky to pull up or push through w/PLA. -
@printrbot removed the heating element by loosening one screw. The filament had bent up inside. Fixed now thx!
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.