Modeling a connector for the tiles in @adskFusion360 & PrusaSlicer
pic.twitter.com/bIXvjDJl8Z
-
Show this thread
-
-
Here's the connector. It's tiny!pic.twitter.com/LstUgv8HiN
1 reply 0 retweets 5 likesShow this thread -
Clipping the connectors into the PCB. I'll probably iterate on the connector design some morepic.twitter.com/aI85pCbUol
3 replies 0 retweets 10 likesShow this thread -
It's coming together! Next step: soldering the tiles on the pads along the edges for power & data
pic.twitter.com/8Y71potecW2 replies 0 retweets 12 likesShow this thread -
All soldered up! Next up: LEDspic.twitter.com/zZNx8EwHxo
1 reply 0 retweets 4 likesShow this thread -
Everything's workingggggg! So happy right now
pic.twitter.com/UFeIlwq0ZB1 reply 1 retweet 14 likesShow this thread -
Time for some more bed-side soldering
pic.twitter.com/ExD4SOWKXd
2 replies 0 retweets 9 likesShow this thread -
-
The Wobble Sphere is coming together!pic.twitter.com/Qzti0BwDEP
11 replies 7 retweets 68 likesShow this thread
-
-
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
