@dosdude1 what temp should I set my iron too when I’m connecting wires for the programmer to a 2011 MacBookPro Logic board to ignore discrete graphics?
-
Many months later and much procrastination later I'm actually getting set up to get to work: the pictures show a line labeled 3V3, but the leads off the JTAG programmer don't have any sockets labeled with that. It's a Lattice HW-USBN-2A. Am I missing something?
-
-
Uh... another question here: DeMux flasher has been sitting with the blue progress bar all the way through for the last several minutes with no notifications.... is this normal?
-
Windows defender was being a little brat. Then of course it failed and I managed to rip a pad off... but I figured out an alternate location to connect TMS and I just put ground under a screw instead of using the solder pad for it. Now I got my Mom's MBP working! Thank you!!!
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.