Finally version of the TrinityLabs MM-1.5+ with new Y axis >> http://brainspl.at/trinity-mendelmax1.5-plus/index.html …
-
-
@bascule sure if you don't mind paying multiple$100's for a print that would cost me less then $0.50 to print on one of my printers -
@ezmobius I totally want one of these, although not for $100: http://www.shapeways.com/model/247116/animaris-geneticus-parvus-7.html …
End of conversation
New conversation -
-
-
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.