There are no words for that unspeakable act
-
-
-
The original plan was to face the pad flat then engrave something into it with a 100 μm endmill. But I snapped the only two I had due to excessive runout on the chuck since I couldn't use a collet because the jig was too short. With a 250 μm endmill all I could do was face it.
Kraj razgovora
Novi razgovor -
-
-
Xacto knife works good too. You can safely remove 0402 device this way, unless it's something leadless like a TVS diode.
-
Lol, this isn't meant to be practical. I was mostly testing how precisely I could control depth on the mill. I have probably five different rolls of desoldering braid in the lab.
Kraj razgovora
Novi razgovor -
-
-
I love how the guys that own mill just use it for the most ridiculous tasks. Need to slice your bread? Mill it. Baking a cake? Stick a spatula on the mill. Desolder some pcb? Mill it

Hvala. Twitter će to iskoristiti za poboljšanje vaše vremenske crte. PoništiPoništi
-
-
-
Hvala. Twitter će to iskoristiti za poboljšanje vaše vremenske crte. PoništiPoništi
-
Čini se da učitavanje traje već neko vrijeme.
Twitter je možda preopterećen ili ima kratkotrajnih poteškoća u radu. Pokušajte ponovno ili potražite dodatne informacije u odjeljku Status Twittera.