I assume a lot of the DFM changes are applied automatically, or irregardless of order comments. (Includes opening up soldermask.) This is likely just due to the volume of order they have to process. When they handle PCBA, they have more time to check?
-
-
-
I could see that. Wish there was a way to just say “do not open the mask” and have it take. I’ll have to try it with pcbway now that I have these reference pics. JLC straight up said “sorry, that’s our mask tolerance. Here is an order credit”
Kraj razgovora
Novi razgovor -
-
-
Most of the overseas places will vary a lot, as pcbway/allpcb/etc are outsourcing the fab AFAIK. I had tried for a time to "test" various ones by ordering same board from multiple "fabs", but even if you reorder board 3 months later from same "fab" it can be totally different.
-
I had fun when PCBWay decided to pull back internal copper more than required for some reason, causing a total break in a power plane on my CW-Nano prototype. Luckily I had ordered from both PCBWay & AllPCB as was time-critical and didn't want to risk delay, so had backup!
- Još 2 druga odgovora
Novi razgovor -
-
-
We use
@PCBWayOfficial for a reasonHvala. Twitter će to iskoristiti za poboljšanje vaše vremenske crte. PoništiPoništi
-
-
-
You need to add
@oshpark to this competition :)Hvala. Twitter će to iskoristiti za poboljšanje vaše vremenske crte. PoništiPoništi
-
-
Tweet je nedostupan.
Čini se da učitavanje traje već neko vrijeme.
Twitter je možda preopterećen ili ima kratkotrajnih poteškoća u radu. Pokušajte ponovno ili potražite dodatne informacije u odjeljku Status Twittera.