the main problem with my amp cabinet project is that a cheap, slightly bowed bandsawn pine 1x6 ripped down to 1 ¼" widths and then worked with tools that haven't seen use in years, by someone who's been out of practice even longer, is not the best material for precision joints.
-
Show this thread
-
conveniently, however, it's cheap and I don't feel bad about screwing up some of the cuts in the process of prototyping, and a better material, like poplar or maybe even oak, isn't a whole lot more expensive either.
1 reply 0 retweets 0 likesShow this thread -
and I have at least established that my design for the corner joints is workable.
1 reply 0 retweets 0 likesShow this thread
it's nice to be building a thing again.
9:12 AM - 11 May 2021
0 replies
0 retweets
1 like
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.




