cj @ scalar

@ScalarElectric

& : in-house gizmos () : EE protips : tweets by CJ, P.E.

Washington, DC
scalarelectronics.com
Joined October 2014
82 Photos and videos Photos and videos

Tweets

You blocked @ScalarElectric

Are you sure you want to view these Tweets? Viewing Tweets won't unblock @ScalarElectric

  1. Pinned Tweet
    May 7

    What do you mean I'm the only electronics development lab and prototype shop in ?

    2 retweets 1 like
  2. Retweeted
    Jun 9

    We are getting closer! Merging soon– the two worlds of ECAD and MCAD! See this EAGLE tutorial

    7 retweets 8 likes
  3. Jun 7

    Super into this. 📦📦📦📦📦📦📦

    2 retweets 5 likes
  4. Jun 6

    Never been so excited to receive foam. Think of the possibilities. It's *foam* you guys. Foam!

    1 like
  5. Jun 5

    Got a bunch of tiny parts? Print 'em 1-at-a-time instead of all-at-once for cleaner, consistent results

  6. Jun 5

    Most underrated piece of engineering test equipment:

    1 reply
  7. Jun 4

    Converting joules to watt-seconds since 1987.

  8. May 29

    Reg'd on to answer a Q. Thorough, included charts! Can't post cause I'm new, used images. Ohwell/Delete/Close/Neveragain lol

    1 reply
  9. May 29

    New sensor samples arrive tomorrow for characterization, pretty excited about it. Prepping the test bench!

  10. May 26

    Never cut off a connector if you can avoid it. Find the mate and plug into it instead! Good electronics advice, good life advice.

    2 likes
  11. May 23

    Hay that's me

    Built with Tindie: Workless Lamp
    1 retweet 2 likes
  12. May 23

    Another swag conversion I like: 1.75mm PLA filament is damn near a gram per foot.

    1 retweet 1 like
  13. May 19

    If a 5¼ floppy disk with Kid Pix on it married The Concept of Sound, their baby would be the ETC by

  14. May 18

    Industrial controls, with my friends at

  15. May 16

    Me too, small plastic robot. Me too.

    1 retweet 1 like
  16. May 14

    Anything that comes in a bottle should come in a bottle that looks like a bear.

  17. May 12

    The most talented hardware product designers of 2040 are presently fourteen-year-olds busy 3D printing fidget spinners. Go easy on them.

    1 like
  18. May 8

    In electronics, you can sometimes *add noise* to make a signal clearer. Everywhere else, not so much. So cut it out.

    1 retweet 1 like
  19. May 8

    60% is 50% more than 40%.

  20. May 7

    After a period of bad prints, my 3D printer just coughed up this shrapnel from a faulty Bowden tube connector. Neat.

    2 likes

@ScalarElectric hasn't Tweeted yet.

Loading seems to be taking a while.

Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.

    You may also like

    ·