Medijski sadržaj
- Tweetovi
- Tweetovi i odgovori
- Medijski sadržaj, trenutna stranica.
-
-
-
-
@LucaBongiorni Wonder how much this thing will cost? https://www.cnx-software.com/2020/01/14/iwave-systems-launches-nxp-i-mx-8quadmax-i-mx-8quadplus-sbc/ … Seems like almost perfect hardware for a@POTAEbox. Dual GbE, HDMI in and out, UDC and UHC, support for LTE modems, etc. Just a bit big, and needs 12V supply.pic.twitter.com/Fo7OWbFVFa
-
-
There was the Phillips IS2630 Inferno-based terminal, started around 1998, which ended up being sold for pennies on the dollar as the TuxScreen. https://www.eetimes.com/strongarm-chip-to-power-advanced-screen-phone-for-internet-e-mail-messaging/ … https://elinux.org/Tux_Screen pic.twitter.com/sDrsDL1V25
-
-
-
First radios in place, still awaiting the CDN and CE ribbon cables before I can test them!pic.twitter.com/t4Atolnz0E
Prikaži ovu nit -
Work in progress, will be a 20 * nRF24l01 transceiver carrier board. Vcc, ground, and SPI pins brought to each module header (black outline). Per device CSN and CE will be run using ribbon cable. Planning to drive the whole lot from an Arduino Mega ...pic.twitter.com/d70ueU9VcG
Prikaži ovu nit -
-
Ah, I see! I’d be interested in an upgraded Microuter, certainly. The attached is what I got from pepe2k. The 9563 definitely works!pic.twitter.com/h96TgYOIAz
-
Side view of the pwnagotchi, with test clips on the uart for debugging purposes.pic.twitter.com/fPXbzwRXyj
Prikaži ovu nit -
Having fun with my
@pwnagotchi. Was quite a mission to get the SPI TFT display working, but that’s not your problem! The bit that caught me was it operating in manual mode when tethered, but again, that’s me not reading the docs!pic.twitter.com/bG9DeZj9ii
Prikaži ovu nit -
In fact, the data sheet explicitly says the second port can operate in device mode! Please tell me that the traces are accessible, or that you can do some sort of experiment to test this? I will buy more of your routers if you make this possible!
pic.twitter.com/jIPr7uMjKX
-
I see the GL857L, however, there are 2 USB ports on the QCA9563. That leaves a second USB port on the CPU that could be connected to the data lines of the microUSB connector. Though the datasheet says USB_CONFIG:4 must be 1, it's worth trying, if the pins are accessible!pic.twitter.com/gfDRxCTHaE
-
@rbjacobs I went out of my way to use an Engen station, but they have no @FNBSA payment terminals. Will I still be credited for filling up at an Engen? I haven’t been in the past!pic.twitter.com/Duiw3A0U1X
-
Woohoo! Goodies from summer camp!! Sincere thanks to
@_MG_ and@slawekja, and to@therealsaumil and@singe for making them halfway across the planet for me!pic.twitter.com/J5MxjYjLOG
Prikaži ovu nit
Čini se da učitavanje traje već neko vrijeme.
Twitter je možda preopterećen ili ima kratkotrajnih poteškoća u radu. Pokušajte ponovno ili potražite dodatne informacije u odjeljku Status Twittera.
