10µF cap in circuit reads infinite resistance with cheap dmm; is it likely/surely blown?
It's in a USB device that gets detected then errors out when connected, and only component aside from IC that looks like it could have been damaged. Switched to 2Mohm mode and it looks ok now tho...
-
-
Or at least it looks like a cap.
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
-
-
Hmm, unfortunately I've never had very good luck figuring out why USB devices stop working. I would have expected the issue to be with the resistors on the USB data lines (if the device has any rather than having them internal to the chip).
-
Just ordering a new one. Doesn't seem to be any time-efficient way to diagnose/fix the one that seems bad...
-
Yup, that's usually the solution for consumer devices like this
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.