Ri3DIndiana
John Riedeman
@Ri3DIndiana Love the Polycarbonate fingers for lifting. We have had trouble bending it successfully in the past, any suggestions?
-
-
-
.
@MrRiedemanJACC like a crock pot of corn, low and slow. Use a heat gun on a low setting and pass over it many times to prevent bubbling. -
@Ri3DIndiana Sounds good - or like soaked corn on the cob still in the husk over a grill... mmmmmm :) You guys did use Polycarbonate right? -
.
@MrRiedemanJACC yup! Also make sure that it's not too thin or too thick. I think we used either 3/16" or 1/8" I'm not too sure anymore.
-
-
-
@Ri3DIndiana You guys tippy? Looks like there are a couple of extra batteries in the back. -
@SnowProblemz Nope! It holds six totes no problem without the extra batt. We were experimenting with ballast because it only weighs 99 lbs! -
@Ri3DIndiana Nice! We're putting some finishing touches on our robot before the "Stop Build Day"#omgrobots#Ri3D
-
-
@Ri3DIndiana Looks really nice! ¡Felicidades amigos!
#omgrobots#Ri3D#recyclerush
'Snow Problem
Panteras
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.