Are you sure you've got the right bit (with the thin sections to allow it to be snapped out) under the kidney-shaped hole? If so, try hammering at it with the blunt end of the knife. Sometimes the "thin" bits of plastic are still pretty thick.
I've got a bloody PhD, & I can't for the life of me figure out how to open the salt!
Help!
pic.twitter.com/nFATEo1saT
-
-
-
I'm not sure about anything anymore!
I've beaten the bit under the kidney-shaped hole to within an inch of its life, but it's staying put.
I'm blaming a manufacturing fault! -
Can you SEE the impressed lines intended to allow the plastic to snap?
End of conversation
New conversation -
-
-
I think you need to push though the kidney shaped hole. You can then rotate the lid for the different pouring options.
-
Well that's what I thought. But it doesn't seem to want to give way. I've been shoving a knife down at it. Maybe it's faulty!
-
That's what I would do as well.
End of conversation
New conversation -
-
-
Turn left.
-
Only the inner part with the grooves.
-
Also, sorry. I didn't see it was 10 h hold. You have figured it out by now. Twatter keeps on reverting to non-chronological order.
End of conversation
New conversation -
-
-
This Tweet is unavailable
-
I've been pushing. Nothing's happening!
-
You might need to use the handle end of a small spoon or fork.
-
I've been jabbing at it with a knife! Maybe I'm just very weak!
-
This Tweet is unavailable
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.