I HAVE RESEARCHED THIS™ actually, the correct hack is to tighten screws to correct torque, note how far they are from correct orientation, then take a light cutting pass on the BACK OF THE HEAD of the screw, to allow them to seat a bit deeper That's what Greene and Greene didhttps://twitter.com/k_d_payne/status/977274931066081280 …
-
-
I feel like a second rate craftsman now. Dammit.
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.