I'd say that people who treat their tools poorly are subhumans, but even morlocks know when to grease things.
and I run into rusted plate, so I fix it in electrolytic bath. Then rusted Y, so I replace it. Then rusted Z so I cut & weld it. However...
-
-
I finally get to a part where I've been kicking the technical debt down stream. I have GOT to get Q apart from R in order to make it work.
-
And the roll pin in Q is rusted solid. So I start disassembling T bc if I can do that I can arbor press the pin out. 3 bolts. 2 come out
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.