1/ Used the four jaw chuck on the Sherline, dialed runout down to 0.001". Carved one ring from wax. Attached to sprue.
3/ Now waiting for investment to harden. In 2 hours I'll "burn out" the wax (using the blacksmith forge in my shop).
-
-
4/ Once that's done I can melt silver in the same forge, then cast a sample ring. This is a dry-run of the process.
-
5/ I should probably order the Au today, given that the drop-dead deadline is 2 weeks + 4 days.
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.