Hit the gym and was reminded that my dumbbell rack is too small. Had good fun welding yesterday...gonna head out to the barn now and check my supply of 2" angle iron ... may solve the problem.
-
Show this thread
-
ⓘ Dogs don't have thumbs Retweeted ⓘ Dogs don't have thumbs
2/ No one cared who I was until I put on the mask.https://twitter.com/MorlockP/status/1341790331185061889?s=19 …
ⓘ Dogs don't have thumbs added,
5 replies 2 retweets 30 likesShow this thread -
-
-
5/ Welds were nice...right up until I ran out of argon a few inches before finishing.
pic.twitter.com/yCOQRU6LmS
1 reply 0 retweets 10 likesShow this thread -
ⓘ Dogs don't have thumbs Retweeted Snake
6/ I GROUND THE PAINT BACK 1/4" FROM ALL THE WELDS !!!https://twitter.com/tigerboy74u/status/1342178619037081601?s=19 …
ⓘ Dogs don't have thumbs added,
2 replies 0 retweets 8 likesShow this thread
ⓘ Dogs don't have thumbs Retweeted jtces
7/ Absolutely could've butt joint3d, and have done so in other projects, but then I'd need all six new pieces to be identical length to, say, 1/32", instead of 1/8, cuts need to be 90.00° not +/- 3°, and alignment gets tricker (need to use a jig).https://twitter.com/jtces/status/1342271166325645312?s=19 …
ⓘ Dogs don't have thumbs added,
-
-
8/ Bitt joint requires better grinding at ends to create a bevel to sink bead into.. And, finally, the overlap gives me extra strength and allows for mediocre welds. Tolerance for error = good.
0 replies 0 retweets 9 likesShow this threadThanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.