Dropped some material, broke the knob off the rip fence on my tablesaw. Replacement is $25. For a knob. I think I'll just fire up the lathe instead, as long as (not sure yet) the knob is just affixed with some standard bolt thread.
-
-
-
-
-
12/ mounted on the table saw and I screwed up a bit - the bolt I used is a bit longer than the hole it mounts into, so 1/4" of thread is visible 'twixt handle and mount. Might cut it off, might just call it done. ¯\_(ツ)_/¯
Show this thread -
13/ yeah, obviously that trial balloon sank in internal testing 2 ms after I floated it I ordered a thread chamfering tool 30 seconds after tweeting - will cut bolt short, chamfer endhttps://twitter.com/random_eddie/status/1280500489944268802 …
Show this thread -
14/ one doesn't NEED a bolt chamfering too - one can thread a nut on before cutting the thread, then back it off and/or one can also clean up the cut thread with files I've done both but for $10 ....
Show this thread -
-
16/ knob / lever lifts vertically / pivots through ~90° ; no knurling required https://twitter.com/GeoGDF01/status/1280552747255857153 …
This Tweet is unavailable.Show this thread -
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.