Designing and building a mitre saw stand today and really want 8' or infeed / outfeed table to either side of saw, but don't remotely have room for 18' of table. Leaning towards 12' of table total. Unsure of setup. 7' to one side, 2' of saw, 3' to other side?
-
-
8/ Current plan is 24" deep, 32" tall, 12' wide. Big plywood box (two, actually, next to each other), subdivided into three 4' wide bays, each open at the front for storage, all atop http://grizzly.com mobile base. This is how I built the CNC base and it works well for me.
Show this thread -
9/ yep, the one I'm using now (purchased back around 1997 or 98 when I was building the addition on my old house) is a Delta with pivoting-out-arms. https://twitter.com/stucknLAwzmbies/status/1238862071544102913 …
This Tweet is unavailable.Show this thread -
10/ Base cabinets done (tho i might add doors later?). Going to buy a new mitre saw (sliding!), then build left / right fences to the matching height. Going atop a Grizzly mobile base (arriving Tuesday).pic.twitter.com/EPOsaQZ4LY
Show this thread -
11/ Cut the rails on the Grizzly mobile base (max length, 21") in half, and welded angle iron in to stretch them.pic.twitter.com/mGFCnWh2YY
Show this thread -
12/ Not ENTIRELY happy w result. Maybe 1/8" of sag in the middle of the run, and it only has 1/4" of ground clearance at the corners, so it almost drags in the center. Thinking of making 2" thick riser blocks for the casters, to life the whole thing up a bit.pic.twitter.com/yXelqKCZPV
Show this thread
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.