THANKS, DAD I NEVER WOULD HAVE THOUGHT OF THAT MYSELF WHAT IS THE CHANCE THAT I WAS MEASURING PLYWOOD THIS MORNING WITH CALIPERS AND CUSTOM RIPPING 2x6s TO WIDTH, DO YOU THINK ?https://twitter.com/bara/status/1237441432970883072 …
-
-
5/ also, I'm aware of tolerance stacking, so it's possible that the finished steps might end up being 18" plus epsilon and not slide under the threshold ... and I considered building each step 1/32" short from the get go, but decided instead to just power plane as needed
Show this thread -
6/ I know this is intended as gentle teasing, but to let you know how deep the OCD goes: actually, yes, I DO do a full dimensioned drawing for everything, on graph paper, then generate a cut list (with part IDs), then put check marks as I cut pieceshttps://twitter.com/tr0g/status/1237445231253041153 …
Show this thread -
7/ it's not CAD and you're correct, there aren't tolerances ...but I do generate plans, label them, then file them away in a 3 ring binder in case I ever want to make another one years later (and sometimes I do)
Show this thread
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.