Accomplishment today: Table (f)
-
-
2/ It's a big sucker. About 4' across and just under 8' long. Need to use the router with a round-over bit to relieve the edges, then I'll hit it with a few coats of oil based polyeurethane.pic.twitter.com/SbKsKkzqg3
6 replies 0 retweets 14 likesShow this thread -
3/ <slaps top of table> "this bad boy can fit so many neoreactionaries and ancaps around it."
1 reply 0 retweets 10 likesShow this thread -
-
5/ I also helped
@LibertyFarmNH make a tabletop for her e̶l̶f̶ ̶v̶i̶l̶l̶a̶g̶e̶ ̶c̶o̶s̶p̶l̶a̶y̶ ̶s̶i̶t̶e̶ HUN retreat. Maple, IIRC, and hide glue.pic.twitter.com/UpS0q8fxy8
1 reply 0 retweets 4 likesShow this thread -
ⓘ Dogs don't have thumbs Retweeted Snake
6/ my cabinetmaker's bench top is made from 2x4shttps://twitter.com/tigerboy74u/status/1181257628686536704 …
ⓘ Dogs don't have thumbs added,
2 replies 0 retweets 5 likesShow this thread -
2 replies 0 retweets 4 likesShow this thread -
ⓘ Dogs don't have thumbs Retweeted SmokinFrog
ⓘ Dogs don't have thumbs added,
1 reply 0 retweets 0 likesShow this thread -
9/ original legs and apron from old kitchen table, repainted in "Lexington Green" milk paint, top coasted with tung oilpic.twitter.com/jxNQN9YRMy
1 reply 0 retweets 6 likesShow this thread -
ⓘ Dogs don't have thumbs Retweeted Hamilton 🌲 🛠 🌳 📐 🐸 ☀️
10/ LOL, quite the reverse! My glue up was terrible and the result had cupping, stair steps between adjacent boards, etc. The level was my constant tool as I worked for HOURS to power plane and power sand it level (ish).https://twitter.com/Watchman_motto/status/1181322379261349890 …
ⓘ Dogs don't have thumbs added,
2 replies 0 retweets 1 likeShow this thread
11/ ...and if you look closely you can see that you could fit a 1/32", maybe even a 1/16" feeler gauge under there in one place. I suck!
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
what are you planning for the legs?