start your week off right https://www.youtube.com/watch?v=sbRom1Rz8OA …
-
-
Yeah, taper doesn’t allow for much, even if there were thread, you’d lose thread engagement clamping down on it. Tack weld is probably best assuming the weld sticks to the cast, or you could drill and pin it.
-
this was the first thing I needed to investigate: is black iron pipe cast iron or not? I've - against advice - tried to MIG cast, and it is - LIKE THEY TELL YOU - not a good idea. Other plan is to cross drill through clamp and pipe and tap in a roll pin (or, hell, a nail...)
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.