I'm trying to construct a simple ("simple") system to distribute water around the barnyard using PEX. Except...there are a mulltiplicity of thread sizes and types. GHT (garden hose thread) male and female. 3/4" NPT (again M & F), 1" NPT (M & F), PEX (1/2", 3/4", 1"). >>>
8/ ...and 90 degree bend supports. We do one straight run of PEX to each destination, where we then convert back from PEX (via sharkbite connector) to 3/4" NPT, which connects to the sow water bowls. Eventually there will be ~ 20 or so zones. For now, though, just 4.
-
-
9/ Phase 2 is to add the remaining zones. Phase 3 is to add bypasses around each manual control valve, which are controlled by DC servos, so that I can have software do it all for us.
Show this threadThanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.