status: "Into the Mouth of Madness", except code
-
-
Yes, 3/16” boring bar on Toolmaker’s dovetail lathe, averaging in high/low reading since parts are only “round” if I’m being charitable, as the diameter varies by .004”.
-
so you're saying that the boring bar deflects enough that the hole is kinda oval? and you remove the bar and measure, and average the measurements, to decide when you're done?
- Show replies
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.