Sheep slaughter is done. Time to get out the new Ar/CO2 tank and do some welding the tractor bucket.
3/ Then stitch welded other edge of tube to bucket. Went back and did a continuous weld on each edge. 2 x 5' Then made templates for open ends of tube (not just 3" X 3" square, bc bucket has flanges partially filling that space. Cut, welded in place. Welded chain hook on top.
-
-
4/ Wife wheeled whole thing, then - bc too cold for primer and paint - rubbed oil over all the clean metal. Will leave it like that til spring, then clean w acetone, prime, and paint.
Show this thread -
Errr... "WIRE wheeled" the steel, not "wife wheeled".
Show this thread
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.