2/ ok, who am I fooling, we both know I don't come here for the hunting...
-
-
Show this thread
-
3/ This is actually a really solid idea. I can buy oil cups with a 1/8" thread, or 10-32 thread, then get a bit of bolt, cut it off, drill and tap a hole down the center... yeah, this is doable...
Show this thread -
4/ the "machining" I did to make a roller removal tool was really a lot closer to "drilling"pic.twitter.com/1F7VymEQML
Show this thread
End of conversation
New conversation -
-
-
Re-tap the holes? Helicoil and teflon tape?
Thanks. Twitter will use this to make your timeline better. UndoUndo
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.