For 20 years I've wanted a plasma cutter, but haven't had an actual valid use before me.
At #HUNV I noticed that the farmhands have !@#-ed up the bucket on the tractor a bit, and I want to repair it by cutting off a 5' long flange, then welding on an equal len of 2" square tube
-
Show this thread
-
2/ And I could cut off that 5' flange with cut off wheels on a 4" angle grinder...but I'd prob spend an hour doing so, and go through half a dozen 5-packs of wheels. I may have just talked myself into this.
1 reply 0 retweets 5 likesShow this thread -
3/ That said, plasma cutters are not cheap (~$1+k), and I've already done by budget for all of 2019, and - WITHOUT buying a plasma cutter - I'm already ~ $20k under water. So...
4 replies 0 retweets 4 likesShow this thread -
This Tweet is unavailable.
-
This Tweet is unavailable.
-
This Tweet is unavailable.
-
This Tweet is unavailable.
-
If I had $1,000 for funzies, I'd buy a Curta [ mechanical ] calculator.
1 reply 0 retweets 1 like -
Replying to @MorlockP @BenzaminRush and
Hard to find a good Curta for only $1k.
1 reply 0 retweets 1 like
Eh, price range seems to be $1 - $1.5 Although if I had $1.5 burning a hole in my pocket, I'd get a plasma cutter instead
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.